Fellowes Binding Machine 30TM User Manual

Ofꢀce Thermal Binder  
TM  
Helios 30  
Please read these instructions before use.  
E
Lire ces instructions avant utilisation.  
F
Lea estas instrucciones antes de usar la máquina.  
S
 
BINDING MACHINE CONTROLS  
I
O
H / K  
A
J
M
C
L
N
G
B
E
F
D
QUICK START GUIDE  
1
2
3
4
5
9
6
7
8
10  
11  
12  
 
3
E
ENGLISH  
CAPABILITIES  
Performance  
Technical Data  
Entry width  
12”  
1.2” / 300 sheets (20lb)  
4 minutes  
30-60 minutes  
1-10 cycles / 1-2 minutes  
Light & beeps  
Yes  
Voltage / Frequency /  
Current(Amps)  
Wattage  
Dimensions (HxWxD)  
Net weight  
Binding capacity  
110-120V AC, 60Hz, 5.5A  
600W  
Binding capacity (max)  
Estimated heat-up time  
Cool down time  
Binding cycles  
Ready indication  
LED interface  
Heat-Shield  
Power Save / Auto shut-off  
Multiple Document Binding  
20.9” x 9.4” x 3.9”  
5.7lb  
The maximum sheet capacity can be a single (up to 300  
sheet max) or multiple documents up to approximately  
300 sheets max.  
Yes  
Eg:  
1 x 300 sheets = 300 max  
5 x 60 sheets = 300 max  
10 x 15 sheets = 150 max  
Yes (30 mins)  
Yes  
IMPORTANT SAFETY INSTRUCTIONS  
CAUTION: Please read before use and keep for future reference.  
When binding;  
- plug the machine into an easily accessible socket.  
- to prevent electrical shock - do not use the appliance close to water, do not spill water on to the appliance, power cord or wall  
socket.  
DO ensure the machine is on a stable surface.  
shelves.  
DO test scrap sheets and set the machine before use.  
DO NOT use appliance if the power cord is damaged.  
DO remove staples and other metal articles prior to binding. DO NOT attempt to open or otherwise repair the machine.  
DO keep the machine away from heat and water sources.  
DO turn off the machine after each use.  
DO unplug the machine when not in use for an extended  
period.  
DO use binding covers designed for use at the appropriate  
settings.  
DO keep away from pets, while in use.  
DO NOT leave the power cord in contact with hot surfaces.  
DO NOT leave power cord hanging from cupboards or  
DO NOT exceed the machines quoted performance.  
DO NOT allow children to use this machine without adult  
supervision.  
DO NOT bind sharp or metal objects (eg: staples, paper  
clips).  
DO NOT bind heat-sensitive documents (eg: tickets, ultra-  
sounds etc).  
DO NOT touch the heating plate while binding - it  
is very hot.  
STORAGE & CLEANING  
Unplug the machine at the wall. Allow the machine to cool.  
The outside of the machine can be cleaned with a damp cloth. Do not use solvents or flammable materials to polish the machine.  
 
4
BINDING MACHINE CONTROLS  
A
B
C
On/off switch (rear side)  
Power On button & LED  
Binding thickness guide  
Timer selection (increase)  
Timer selection (decrease)  
Select / OK button  
I
Lid lock (2)  
J
Binding channel  
Document support  
Illuminated user interface  
Cooling vents  
K
L
M
N
O
D
E
F
Document clamp (binding)  
Cooling rack  
G
H
Thickness setting / timer selection  
Lid  
FEATURES & TIPS  
‘System-Check’ function  
Always put the document into the appropriate  
sized binding cover.  
When switched on, the machine performs a  
‘System-Check’ function. The control panel  
illuminates LED neons in sequence to check  
their operation.  
For better results, consider including blank  
sheets to fill the thermal cover to capacity.  
Always test bind with a similar size and  
thickness of thermal covers before final process.  
Helios has an angled heater mechanism to  
ensure correct document alignment with the  
document support during the binding process.  
For best results, use Fellowes® brand  
supplies.  
Thermal binding covers work best with thin  
and uncoated types of paper. Care should be  
taken with thick and coated papers to ensure  
satisfactory results.  
If the sheets have not been glued completely to  
the cover, the document can be re-processed to  
improve the result.  
Ensure the sheets are well aligned and  
touching the glued spine of the thermal cover  
by tapping the collated document in the cover  
onto a flat surface. This can be done before  
and after the binding process.  
‘Heat-Shield’ function  
The document clamp operates as a ‘Heat  
Shield’ to prevent operators from accidentally  
touching the heating plate.  
Auto-Off’ function  
If the machine is not active for 30 minutes, the  
Auto-Off’ function will place the machine into  
standby mode. The ’Power-On’ LED will flash  
red and green. To operate the machine, press  
the ‘Power-On’ button.  
 
5
BEFORE BINDING  
1. Ensure the machine is on a stable surface. Check  
there is enough clear space around the machine to  
operate safely.  
Plug the machine into an easily accessible main  
socket. Switch the main supply on.  
3.  
4. Open and lift the lid by releasing the safety catches  
2. Insert the power lead into the power socket (located  
on the front of the lid.  
at the rear of the machine).  
HOW TO BIND  
Switch the power on (located at the rear side).  
Pull open the document clamp (Heat-Shield fea-  
5.  
9.  
ture), insert the documents into the binding channel.  
Ensure the binding covers spine touches the heating  
element.  
The ‘Power-On’ button will be red. To activate the  
6.  
machine, press the ‘Power-On’ button on the control  
panel. The machine will warm-up, the red LED will  
flash. The machine will ‘beep’ (3x) and the LED  
turns green when the machine is ready to bind.  
Start the binding cycle by pressing the ‘Select / OK’  
10.  
button. The blue LED will start flashing and counting  
down, in sequence. When the cycle is complete, the  
machine will beep (3x). The blue LED will switch off.  
7. Prepare the documents by loading the sheets into  
the thermal covers. For best results, do not to place  
too many or too few sheets into the cover. Use the  
binding thickness scale as a guide. The guide is cali-  
brated in 6mm widths. Helios 30 will accept single or  
multiple documents up to a combined total thickness  
of 1.25” (approximately 300 sheets / 20lb).  
11.  
The machine has an integral cooling tray. It can be  
extended from the back of the machine and can also  
be pulled upwards to accept larger documents.  
When the binding cycle is complete, immediately  
12.  
remove the documents and place in the cooling tray  
or on a flat surface to allow the document to cool.  
The document can be removed from the machine  
mid-cycle if required, take care – the glue may be  
hot and melted.  
The selected binding cycle is shown with blue LED.  
8.  
Use the timer selection buttons to navigate up or  
down the scale, if required. The scale has 10 settings.  
Eg: 0.25” document thickness = setting 1 (up to  
60 sheets), 1.25” document = setting 10 (up to 300  
sheets).  
NEED HELP?  
Let our experts help you with a solution.  
Customer Service... www.fellowes.com  
Always call Fellowes before contacting your place of purchase,  
see the rear cover for contact details.  
 
6
TROUBLESHOOTING  
Problem  
Possible cause  
Solution  
Switch on machine at rear next to plug  
inlet and at the wall socket  
Move the machine to a cooler and dry  
area  
No ‘red’ power on LED  
Machine is not switched on  
No ‘green’ ready light after a long  
period  
Machine is in a hot or humid area  
Process the documents again, ensure  
Binding cover may be too thick to bind sheets are in contact with the glued spine  
by tapping gently on a flat surface  
Loose and unglued sheets  
Check timer setting is correct and process  
Timer setting may be incorrect  
the document again  
Check the number of sheets is appropri-  
The cover size is too small for the  
ate for the cover width. Select larger  
number of sheets  
spine width if necessary  
Extended heating cycle  
Loose and glued sheets  
Timer setting may be incorrect  
Documents left on the heater plate  
after the cycle is complete  
Check timer setting is correct. Ensure  
prompt document removal  
WORLDWIDE WARRANTY  
Fellowes warrants all parts of the binder to be free of defects in material and workmanship for 2 years from the date of  
purchase by the original consumer. If any part is found to be defective during warranty period, your sole and exclusive remedy  
will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of  
abuse, mishandling or unauthorised repair. Any implied warranty, including that of merchantability or fitness for particular  
purpose, is hereby limited in duration to the appropriate warranty period set forth above. In no event shall Fellowes be liable  
for any consequential damages attributable to this product. This warranty gives you specific legal rights. You may have other  
legal rights that vary from this warranty. The duration, terms and conditions of this warranty are valid worldwide, except where  
different limitations, restrictions or conditions may be required by local law. For more details or to obtain services under this  
warranty, please contact Fellowes or your dealer.  
PRODUCT REGISTRATION  
Thank you for purchasing a Fellowes product. Please visit www.fellowes.com/register to register your product and benefit  
from product news, feedback and offers. Product details can be found listed on the rating plate positioned on the rear side or  
underside of the machine.  
 
7
FCC CLASS B NOTICE - NOTIFICATION POUR LES ETATS-UNIS  
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the  
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.  
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the  
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not  
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the  
following measures:  
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and receiver.  
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  
• Consult the dealer or an experienced radio/TV technician for help.  
CANADA CLASS B NOTICE - AVIS CANADA, CLASSE B  
This Class B digital apparatus complies with Canadian ICES-003.  
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.  
MODIFICATIONS  
Any modifications made to this device that are not approved by Fellowes may void the authority granted to the user by the FCC  
and/or by Industry Canada to operate this equipment.  
Toutes modifications apportées à ce dispositif et non approuvées par Fellowes annuleront le droit accordé à l’utilisateur par le  
FCC et/ou par Industrie Canada de faire fonctionner cet équipement.  
Fellowes  
Australia  
Benelux  
+61-3-8336-9700  
+31-(0)-76-523-2090  
+1-905-475-6320  
Korea  
+82-(0)-2-3462-2844  
+60-(0)-35122-1231  
+48-(22)-771-47-40  
+7-(495)-228-14-03  
+65-6221-3811  
Malaysia  
Polska  
Canada  
Deutschland  
España / Portugal  
France  
+49-(0)-5131-49770  
+ 34 902 33 55 69  
+33-(0)-1-78-64-91-00  
+39-71-730041  
Russia  
Singapore  
United Kingdom  
United States  
+44-(0)-1302-836836  
+1-630-893-1600  
Italia  
Japan  
+81-(0)-3-5496-2401  
 
2008 Fellowes, Inc. Part No. 403838  

Code Alarm Remote Starter CA611 User Manual
Conair Electric Shaver HCT300GB User Manual
Dualit Blender Kitchen Blender User Manual
Eaton Electrical Marine Radio IB 29C892B User Manual
EdgeStar Ice Maker HZB 12 User Manual
Euro Pro Electric Steamer KS315 User Manual
Fender Musical Toy Instrument 2016 Limited User Manual
GE Dishwasher GDWT100 User Manual
Gitzo Camcorder Accessories GT2931EX User Manual
Global Machinery Company Chainsaw PCH25 User Manual